9
1
SETUP
Read the Operation Manual before setting up the Life Fitness Cross-Trainer.
Where to Place the Life Fitness Cross-Trainer
Follow all safety instructions and move the Life Fitness Cross-Trainer to the location in which it will be used. See Section
7 for the dimensions of the footprint. Allow 2 feet (0.6 meters) of clearance around the Life Fitness Cross-Trainer to allow
for movement of the pedal levers. It should be easy to mount the Life Fitness Cross-Trainer from the side.
How to Stabilize the Life Fitness Cross-Trainer
After placing the Life Fitness Cross-Trainer in position, check the unit’s stability by attempting to rock it. Any slight rocking
indicates that the unit must be leveled. Check the stabilizing feet to determine which foot does not rest fully on the floor.
Rotate the foot counter-clockwise to lower it. Recheck the stability and adjust again as needed until the Life Fitness
Cross-Trainer is stable and no longer rocks. Lock the adjustment into position by tightening the jam nut against the
stabilizer bar with an open end 9/16 inch wrench.
Plug In the Life Fitness Cross-Trainer (
DOMESTIC UNITS ONLY
)
The Life Fitness Cross-Trainer comes with a standard power supply. Insert
the power adapter jack into the barrel plug on the back of the Life Fitness
Cross-Trainer. Then insert the power supply into the wall outlet. Make
sure the cord is routed so that it doesn’t bind and will not be walked on.
Check that the console LEDs light up. If not, recheck the plug and wall
connections and make sure the wall outlet has power.
Note:
International units are self-powered only.
Use only the power supply
provided by Life Fitness in order to insure against unsafe operation.
Service Access Port
The two interchangeable type RJ45 networking ports (A) are located on the back of the
display console. These network ports, located behind the display console rear access
door, allow for console software updates.
A
