Life Fitness ATV15-XXXA-02, Руководство по сборке

Страница: 26 / 36

46 47
FOR 95R ELEVATION INSPIRE UNITS ONLY:
3. Cable Routing
3a. Carefully pull the MEDIA CABLE BUNDLE (12) (Power and Coaxial) from inside the CONSOLE BRACKET
(15). Unbundle and straighten the media cables.
3b. Install the coaxial extension coupler and coaxial extension cable.
3c. Tape the ends of all CABLES (Power, Coaxial, I-R Remote Control, Video) together.
4. Feed the taped end of the MEDIA CABLES (12) through the large hole in the back of the CONSOLE BRACKET (15).
Carefully pull excess media cable through the CONSOLE BRACKET.
5
Slide one GROMMET (16) over the taped end of the MEDIA CABLES (12).
6. Hold the MAIN BRACKET ASSEMBLY (5) close to the CONSOLE BRACKET (15) as shown. With the holes facing
upward, feed the taped end of the MEDIA CABLES (12) through the bottom large hole of the main bracket
assembly and out of the upper hole as shown. Carefully pull excess media cable through the main bracket
assembly.
7. Slide the remaining GROMMET (16) over the taped end of the MEDIA CABLES (12).Install the grommets into the
access holes.
8. Install the MAIN BRACKET CAPS (19) to the top and bottom of the MAIN BRACKET ASSEMBLY (5).
9. Secure the MAIN BRACKET ASSEMBLY (5) using four SCREWS (17) and WASHERS (18) as shown. Tighten the
screws securely. (8-10 ft. lbs.)
10. Connect Cables to Console
10a. Connect the I-R REMOTE CONTROL (A) and VIDEO (B) CABLES to the back of the DISPLAY CONSOLE.
95R ELEVATION INSPIRE UNITS ONLY
5
19
16
9
19
15
18
17
B
A
12
Models: 95R Elevation Discover SI & Explore
Tools Required: Phillips Screwdriver, Metric Allen Set, M16 & M17 Wrench
Parts Not Used From Kit: (1) Lower Mounting Bracket
For 95R Elevation Inspire Units Only:
a. Remove the protective liner from one of the provided fastener strips. Attach the fas-
tener strip to the
bottom of the POWER BLOCK (1). Interlock the
remaining fastener strip to the installed fastener strip.
Remove the remaining protective liner from
fastener strip and secure the power block to the
underside of the center frame as shown.
Connect
the SCREW-TYPE CONNECTOR of the
POWER CORD (2) to the underside receptacle.
Bundle excess power cord and store under the
unit. Connect the COAXIAL CABLE (3) to the broadcast
supply receptacle in similar fashion.
b. Connect the POWER CORD to the POWER BLOCK (1).
1. Attach the TV BRACKET (with bent tab) (4) to the MAIN BRACKET (5) as
shown using four SCREWS (6) and WASHERS (7). Tighten the screws
securely. (8-10 ft. lbs.)
2. Remove the four SCREWS (8) securing the REAR CONSOLE COVER (9) to
the frame. Remove the rear console cover.
Remove the four SCREWS (10) securing the insert (11) as shown. Set the
rear console cover aside.
Remove the CONSOLE (13).
1
2
3
4
7
6
5
8
9
10
11
13