LG WK2 S6 Series, Руководство пользователя

Страница: 26 / 80

26
INSTALLATION
NOTE
• If necessary, the correct nozzle (for the LP nozzle
kit, order part number 383EEL3002D ) should be
installed by a qualified technician and the
change should be noted on the dryer.
• All connections must be in accordance with local
codes and regulations. Gas dryers MUST exhaust
to the outdoors.
High-Altitude Installations
The BTU rating of this dryer is AGA-certified for
elevations below 3048 m.
If your gas dryer is being installed at an elevation
above 3048 m, it must be derated by a qualified
technician or gas supplier.
Connecting the Water
Supply Hose
Note for Connection
• Water pressure must be between 50 kPa and
800 kPa (0.5 ‒ 8.0 kgf/cm²). If the water pressure
is more than 800 kPa , a decompression device
should be installed.
• Periodically check the condition of the water
supply hose and replace the water supply hose if
necessary.
NOTE
• Do not overtighten the water supply hose or use
mechanical devices to tighten onto the inlet
valves.
• No further backflow protection required for
connection to the water inlet.
Checking the Rubber Seal
Two rubber seals
a
are supplied with the water
supply hose. They are used for preventing water
leaks. Connection to taps is sufficiently tight.
• Do not use mechanical devices such as multi
grips to tighten the water supply hose. Ensure
that the curved end of the water supply hose is
connected to the appliance.
Connecting the Hose to the
Water Tap
Connecting Screw-Type Hose to Tap with Thread
Screw the supply hose connector onto the water
supply tap.
Connecting Screw-Type Hose to Tap Without
Thread
1
Loose the 4 fixing screws
a
.
2
Remove the guide plate
b
if the tap is too large
to fit the adapter.