LG LDG4313BD, Руководство по обслуживанию

Страница: 47 / 93

5. CONVERT THE OVEN BURNER ORIFICES
1) UPPER OVEN BAKE BURNER
a) Remove oven door, oven bottom, frame
guide, nozzle case and oven burner
assembly (See the page 3-12).
b) Remove the orifice spud from nozzle holder
using a 13/32” or 10mm wrench.
c) Install the LP orifce spud(F) to the nozzle
holder. To prevent leakage, make sure the
orifice spud is securely screwed into the
nozzle holder.
2) ACTIVE CONVERSION BURNER
a) Remove oven door, Fan cover and burner
cover U (See the page 3-13).
b) Remove the orifice spud from nozzle holder
using a 13/32” or 10mm wrench.
c) Install the LP orifce spud(G) to the nozzle
holder. To prevent leakage, make sure the
orifice spud is securely screwed into the
nozzle holder.
5-3
CONVERSION TO LP GAS
WARNING
• Turn off the electrical supply and
gas supply going to the range.
• Replace all panels and parts before
operating.
• RECONNECT all grounding devices.
- Failure to do so can result in severe personal
injury, death or electric shock.
CAUTION
• Use caution when handling sheet
metal parts while servicing the
range.
- Some parts may have sharp edges, which
could result in injury.
4) To prevent leakage, make sure the orifice
spuds are securely screwed into the gas
supply tubes.
5) For the right front bumer of LDG4315 /
LDG4313, the choke and self threading screw
will be needed as shown Fig Insert the choke
into the burner base, then insert the set screw
into the burner base and tighten securely.
Make sure the screw head is against the
shoulder (within choke notch), so it does not
have any rotational movement.
6) Put the old orifice spuds into conversion kits
and place back on the range for possible
future conversion.
NOTE: If an orifice spud is accidentally
dropped, the cooktop plate can be
raised (see the page 3-5)
Self threading
screw
Choke
18.5k burner
base
<Fig>