LG LDF7774BB, Руководство по обслуживанию

Страница: 25 / 68

For Authorized Service Technician For Authorized Service Technician
- 25 -
- 22 - - 22 -
A. TROUBLE SHOOTING ACCORDING TO DISPLAYED ERROR MESSAGE
ERROR MESSAGE
POSSIBLE CAUSE
REMEDY
FOR ERROR OCCURRENCE
The Water Supply Tap is closed.
The Water Supply is shut off.
The Inlet Hose is kinked.
The Water Pressure is very low
(below 10 psi) or high(above 120 psi)
Inlet Valve is OK?
The filter of Inlet Valve is clogged
by impure water.
The Hall sensor is OK?
The Impeller of Air Guide is bound.
The Drain Hose kinked or blocked.
Wiring connection is OK?
The drain outlet of sump is
blocked.
The Drain Pump/Motor or circuit is
No drainage though drain pump is
working properly? Air in the
impeller of the drain pump might
cause this case.
The Air gap is clogged.
Knockout plug of garbage disposal
not removed.
troubled.
Water leakage in Hose connections.
Water is leaked by damages.
The Motor Water Seal leakage of
Sump assembly.
The height of Drain Hose connection
(sink-Drain Hose) is not over 20 .
Impeller of the W
The float assembly is not working.
The lower tub gasket came
loose or fell off.
ashing Pump is
worn away.
Remove the cause of kink or block.
Check the wiring connection.
Measure the electric resistance of
Drain Motor. (20-40 )
Replace the Drain Motor or repair
Remove all the water remained in
the drain hose that is connected to
the drain pump / motor.
Keep the unit upright, don't lay it
down.
Cautious about leaking on the floor.
Clean the air gap.
Remove knock out plug.
the Circuit.
Replace the connections of Hose.
Check the point of damages and
repair or replace the related parts.
Read the Installation Instructions
(page 44) and fix it to the
recommended Height.
Replace the Impeller of the
Change the float assembly.
Replace the lower tub gasket.
※
Remove water near the Float
ASM before the repair.
Washing Pump.
Take action on Water Supply
device.
Measure the electric resistance of
Inlet Valve. (23~27 )
Clean the filter of Inlet Valve.
Check the frequency of Inlet Water
by the Test Mode.
Replace the Air Braker.
Not reached to the nor-
mal water level in spite
of 10 min. water supply
INLET ERROR
displayed
Condition
Not fully drained out in
spite of 5 min. drain
operation
The excessive RPM of
Washing Motor
happened during Wash
cycle due to water
leakage.
DRAIN ERROR
displayed
Condition
LEAKAGE ERROR
displayed
Condition
8.TROUBLE SHOOTING METHODS
or
7. TROUBLE SHOOTING METHODS