LG AHBW Series, Руководство по установке

Страница: 38 / 81

Wiring and Water Piping for Unit
38 Air-to-Water Heat Pump
Control terminal
(Terminal for connecting cable)
Main power terminal
(Terminal for power cable)
General consideration
Followings should be considered before beginning unit wiring.
• Field-supplied electrical components such as power switches, circuit breakers, wires, terminal
boxes, etc should be properly chosen with compliance with national electrical legislation or
regulation.
• Make it sure that supplied electricity is enough to operate the unit, electric heater, water tank
heater, etc. The capacity of fuse also selected according to the power consumption.
• The main electricity supply should be dedicated line. Sharing main electricity supply with other
devices such as washing machine or vacuum cleaner is not permitted.
• Before starting wiring job, the main electricity supply should be turned off until wiring is completed.
• When adjusting or changing wiring, the main electricity supply should be turned off and ground wire
should be connected securely.
• Installation place should be free from the attack of wild animal. For example, mice's wire attacking or
frog's entering into the unit may cause critical electrical accident.
• All power connections should be protected from dew condensation by thermal insulation.
• All electrical wiring should comply with national or local electrical legislation or regulation.
• The ground should be connected exactly. Do not earth the unit to the copper pipe, steel fence at the
veranda, city water outlet pipe, or any other conductivity materials.
• Fix all cable using cord clamp tightly. (When cable is not fixed with cord clamp, use additionally
supplied cable ties.)
Wiring procedure for power cable
Step 1. : Disassemble the side panel from the unit by loosing screws.
Step 2. : Connect power cable to main power terminal
See below figure for detailed information. When connecting earth cable, the
diameter of cable should be bigger than 1.6mm
2 to secure safety. The earth cable is
connected to the terminal block where earth symbol is marked.
Step 3. : Use cable clamps (or cord clamps) to prevent unintended move of power cable.
Step 4. : Reassemble the side panel to the unit by fastening screws.
Main power terminal
(Terminal for power cable)
Control terminal
(Terminal for connecting another
control box beside)
Cable clamp