58
206-4334
Cloning Procedures (Cont.)
(Continued from previous page)
12. When you are ready to continue, select
UPDATE
on the screen and then press the Wheel
(
OK
) button on the Installer Remote.
Import progress will be displayed on the screen. This process may take a few minutes. Do
NOT remove the USB device while importing is in progress. When the import process is
complete, an “Import
Clone File is completed” pop-up message will briefly be displayed on
the screen, and then, the TV will reboot.
13. Remove the USB memory device from the Target TV, and verify that the appropriate
configuration is now resident on the Target TV.
Note:
If the Target TV was previously in Pass-through Mode, and the
Clone/Configuration (.tlx) file
that was imported contained an FTG Channel Map, the Target TV CPU is now in FTG Mode. Upon
restart, the TV tunes according to the Start Channel setting in the Installer Menu. If a Start Channel
is specified, the
TV
will tune to that channel, though, in the case of FTG Mode configuration, a
channel banner will only be displayed if the Start Channel is included in the FTG Channel Map
(depending on your selection in step 11, the channel banner will display either the Start Channel’s
logical channel number or physical RF channel number). Otherwise, the TV will either return to the
last channel tuned (TV in Pass-through Mode) or tune to the first channel in the FTG Channel Map
(TV in FTG Mode). If the latter, remember that the channels in the FTG Channel Map are always
arranged in logical order, regardless of your selection in step 11.
