17
Using printer menus
Power Saver
Specifies the amount of time
(in minutes) the printer waits
after a job is printed before it
goes into a reduced power
state.
Disabled
This value does not appear unless
Energy Conserve is set to Off. See the
User’s Guide for more information.
1...240
Specifies the amount of time after a
print job before the printer goes into
Power Saver mode. (Your printer may
not support the entire range of values.)
The factory default Power Saver setting
depends on your printer model. Print
the menu settings page to determine
the current Power Saver setting. When
the printer is in Power Saver mode, it is
still ready to receive print jobs.
Select 1 to put the printer in Power
Saver mode one minute after it finishes
a print job. This uses much less energy,
but requires more warm-up time for the
printer. Select 1 if your printer shares
an electrical circuit with room lighting
and you notice lights flickering.
Select a high value if your printer is in
constant use. Under most
circumstances, this keeps the printer
ready to print with minimum warm-up
time. Select a value between 1 and 240
minutes if you want a balance between
energy consumption and a shorter
warm-up period.
Alarms
Controls whether the printer
sounds an alarm when the
printer requires operator
intervention.
Alarm Control:
Off
Single*
Continuous
Off—Printer does not sound an alarm.
Single*—Printer sounds three quick
beeps.
Continuous—Printer repeats three
beeps every 10 seconds.
Note: Staple and hole punch alarms
appear only when an optional finisher is
installed.
Toner Alarm:
Off*
Single
Continuous
Staple Alarm:
Off*
Single
Continuous
Menu selection
Purpose
Values
