12
Using printer menus
Custom Types
This menu selection is used to define a name for each custom paper type. You can assign names using a utility such as
MarkVision or from the operator panel.
Universal Setup
This menu selection is used to specify the height and width of the Universal Paper Size. By specifying the height and width
for Universal Paper Size, the printer will use the Universal setting exactly like other paper sizes, including support for duplex
and n-up.
Card Stock Loading Properly handles preprinted card
stock whether the job is a duplexed
or single-sided job.
Duplex
Off*
Shown if Card Stock is supported in
the specified input source.
Custom <x>
Loading
Properly handles preprinted
custom paper whether the job is a
duplexed or single-sided job.
Duplex
Off*
Shown if the custom type is
supported in the specified input
source.
Menu selection
Purpose
Values
Custom Type N
Specifies the type of paper
associated with each Custom
Type available in the Paper
Type menu.
Paper*
Card Stock
Transparency
Labels
Vinyl Labels
Envelope
The custom type media must be
supported in the input source you
designate in order to assign a user-
defined name.
Once the name is assigned, the name
(truncated to 16 characters) will be
displayed instead of
Custom Type x
.
Menu selection
Purpose
Values
Units of Measure
Determines the unit of
measure used to enter the
Universal Height and Width.
Inches
Millimeters
Inches is US default; Millimeters is
international default.
Portrait Width
Sets the portrait width of the
universal media.
Note: If the value set exceeds
the maximum width, the
printer will use the maximum
value allowed in inches or
millimeters.
3 inches to 14.17 inches
in 0.01 inch increments
76 mm to 360 mm in 1
mm increments
Shows either inches or mm from Units
of Measure setting; 8.5 inches is the US
default, and 216 mm is the international
default.
Portrait Height
Sets the portrait height of the
universal media.
Note: If the value set exceeds
the maximum height, the
printer will use the maximum
value allowed in inches or
millimeters.
3 inches to 14.17 inches
in 0.01 inch increments
76 mm to 360 in 1 mm
increments
Shows either inches or mm from Units
of Measure setting; 14 inches US
default, 356 international default.
Feed Direction
Specifies the feed direction of
the Universal Paper Size.
Short Edge*
Long Edge
Long Edge is only shown if the longest
edge is shorter than the Maximum
Physical Width of the printer.
Menu selection
Purpose
Values
