LevelOne ProCon GSW-1290, Руководство пользователя

Страница: 116 / 144

LevelOne GSW-1290 Gigabit Layer2 SNMP Switch
SNMP Host Table
Use the SNMP Host Table to set up SNMP trap recipients.
Open the Management folder, and then the SNMPV3 folder. Finally, click on the SNMP Host Table link.
This will open the SNMP Host Table window, as shown below.
To delete an existing SNMP Host Table entry, click the corresponding X icon under the Delete heading.
To display the current settings for an existing SNMP Group Table entry, click the blue link for the entry
under the Host IP Address
heading.
Figure 6- 10. SNMP Host Table window
To add a new entry to the Switch’s SNMP Group Table, click the Add button in the upper left-hand corner
of the SNMP Host Table window. This will open the SNMP Host Table Configuration window, as shown
below.
SNMP Host Table Configuration
Figure 6- 11. SNMP Host Table Configuration window
The following parameters can set:
Parameter Description
IP Address Type the IP address of the remote management station that will serve as
the SNMP host for the Switch.
SNMP Version V1 – Specifies that SNMP version 1 will be used. V2c – Specify that
SNMP version 2c will be used. V3-NoAuth-NoPriv – Specify that the
SNMP version 3 will be used, with a NoAuth-NoPriv security level. V3-
Auth-NoPriv – Specify that the SNMP version 3 will be used, with an
Auth-NoPriv security level. V3-Auth-Priv – Specify that the SNMP version
3 will be used, with an Auth-Priv security level.
116