Page 8
2: Basic Setup
Overview
Basic Setup of your Multi-WAN VPN Router involves the following steps:
1. Attach the Multi-WAN VPN Router to a PC using any LAN port (5 to14) and configure it for your
LAN.
2. Install your Multi-WAN VPN Router in your LAN and connect the Broadband Modem(s).
3. Configure your Multi-WAN VPN Router for Internet Access.
4. Configure PCs on your LAN to use the Multi-WAN VPN Router.
Requirements
One (1) up to four (4) DSL or Cable modems, each with an ISP Internet Access account.
Network cables. Use standard 10/100BaseT network (UTP) cables with RJ45 connectors
TCP/IP network protocol must be installed on all PCs.
Procedure
1. Configuring the Router for your LAN
1. Use a standard LAN cable to connect your PC to any LAN port (5 -16) on the Multi-WAN VPN
Router. (WAN ports from Port 1 ~ 4)
2. Connect the power cord into the power outlet on the rear panel of the Multi-WAN VPN Router.
3. Power-on your PC. If your PC is already running, restart it. It will then obtain an IP address from
the Multi-WAN VPN Router.
4. Open your WEB browser.
5. In the
Address
or
Location
box enter:
HTTP://192.168.1.1
6. You will be prompted for the User Name and password, as shown below:
Figure 2-1: Password Dialog