PAGE 5 OF 21
Q
STEP 7
Secure the Reflector Caps [
Q
] to the open ends of the Female Tubes [
K
]. [Figure 11].
K
[Figure 11]
STEP 6
Slide the 5/8 Plastic Bushing [
F
] onto the Hand-Tighten Silent Hitch
Pin [
D
].
In the same manor as Step 2, insert and thread the Hand-Tighten
Silent Hitch Pin [
D
] with the Plastic Bushing [
F
] through the Flat Pipe
[
A
], Female Tubes [
K
] and internal Spring Nut [
G
] [Figure 10]. Secure
with Retainer Clip [
B
].
NOTE:
The Hand-Tighten Silent Hitch Pin [
D
] controls the slide out
function of the BlackBox Carrier. Once installation is complete, the
Hand-Tighten Silent Hitch Pin may be removed and the carrier can be
slide rearward for rear hatch/door access.
[Figure 10]
D
K
B
G
F
Never operate vehicle without the Hand-Tighten Silent Hitch Pin [
D
] sufficiently tighten to prevent the carrier from
sliding while in transit. Failure to do so may result in bodily injury and property damage.
WARNING:
STEP 8
Set one Frame Angle [
L
] on top of the Female Tubes
[
K
].
NOTE:
Be sure that this Frame Angles’ [
N
] shorter
end
faces away from the vehicle as shown
.
Bring one (1) Hat Bracket [
M
] up from underneath
each Female Tube [
K
] to connect to the Frame Angle
[
L
],
Using two (2) M8 Carriage Bolts [
N
], two (2) M8
Washers [
O
], and two (2) M8 Nuts [
P
] connect each
Hat Bracket [
M
] to the Frame Angle [
L
] as shown
[Figure 12].
Hand-Tighten only at this time, further adjustment
will be required before final assembly.
O
P
A
L
K
M
N
[Figure 12]
