PAGE 12 OF 21
[Figure 34]
STEP 21
STEP 22
NN
Attach two (2) LED Mount Brackets [
] to
the Side Rail [
T
] on the side of the carrier
facing away from the vehicle using two (2)
K-Lath Self Tapping Screws [
FF
] (one per LED
Mount Bracket). [Figure 33].
NOTE:
The K-Lath Screw [
FF
] should be
installed approximately 12in from each end of
the Side Rail centered between the U-Tubes
[
U
].
Remove the Washer and Nut supplied on the back side of
one (1) LED Light [
NN
].
On the passenger side of the vehicle
, mount the LED Light
[
NN
] (Green Wire) onto LED Mount Bracket [
] using the
supplied Phillips Screw on the LED Light [Figure 34].
Secure the LED Light [
NN
] to the LED Mount Bracket [
]
by re-attaching the supplied Washer and Nut onto the back
of the LED Lights and LED Mount Bracket.
NOTE:
The LED Light [
NN
] with the Green Wire must be
installed on the Passenger side of the Vehicle.
FF
T
U
[Figure 33]
Supplied LED Hardware
TOOLS: TWO (2) 7/16 WRENCH OR SOCKET
TOOLS: 7MM WRENCH & PHILLIPS HEAD SCREW DRIVER
From underneath the carrier, connect the quick-link end
of the Safety Cable [
R
] to the hole in the frame of the
Flat Pipe Spine [
A
] [Figure 32].
NOTE:
The Safety Cable [
R
] can be secured in two (2)
positions. Securing the Safety Cable to the 1st Position
is ideal; carriers positioned for maximum clearance will
need to use the 2nd Safety Cable position.
STEP 20
1st Position
2nd Position
Never operate the carrier’s slide out function or the
tow vehicle without confirming the Safety Cable fully
secured. Failure to follow product guidelines may
result in bodily injury and property damage.
WARNING:
R
A
[Figure 32]
UNDERNEATH CARRIER VIEW
