PAGE 11 OF 21
STEP 18
Insert Plugs [
HH
] into the large holes of the Side Rails
at each corner of the carrier (total 4) [Figure 29].
HH
STEP 19
The BlackBox cargo carrier enjoys between 6in-12in of installed clearance from the vehicle and between 25in-
32in of clearance from the vehicle when slid out.
With the Hat Brackets [
M
] from STEP 8 & 9 still loosely secured, slide the carrier back and forth along the Female Tubes
[
K
] to adjust for required vehicle clearances (user discretion).
NOTE:
Users wanting
more clearance
between the tow vehicle and carrier should position the Hat Brackets [
M
] further
away from the vehicle on the Female Tubes [
K
] [Figure 30].
DO NOT
surpass the Hand-Tighten pin.
NOTE:
Users wanting
less clearance
between the tow vehicle and carrier should position the Hat Brackets [
M
] closer to
the vehicle on the Slide Tubes [
K
] [Figure 31].
DO NOT
overlap the Hand-Tighten warning sticker.
Once the final clearance adjustments have made, confirm the aligned Female Tubes [
K
] are slid all the way back against
the Rubber Bummers [
I
] and then fully secure all Hat Brackets [
M
] and hardware from Steps 8 & 9.
NOTE:
Be sure to allow room for the Hand-Tighten Hitch Pin [
D
] to turn and operate as required.
M
M
K
K
D
D
DO NOT ALLOW HAT BRACKETS TO OVERLAP THE 3.5” WARNING LABEL LOCATED ON
ON THE SLIDE TUBE.
Failure to do so will permit overextension of the safety cable allowing the
capsule to fall off and cause damage or personal injury.
WARNING:
MIN INSTALLED CLEARANCE
MAX INSTALLED CLEARANCE
WARNING
WARNING
[Figure 30]
[Figure 31]
[Figure 29]
TOOLS: 1/2” WRENCH
