PAGE 4 OF 21
STEP 3
Slide one (1) Rubber Bumper [
K
] onto
each Flat Pipe Spine [
A
] tube (total 2).
Push the Rubber Bumpers along the
tubes until they sit flush against the
frame of the FlatPipe Spine [Figure 5 &
6].
Using the provided water-proof Wax
Block [
J
], rub along all four sides of each
Spine tube to completely “coat” the Spine
tubes [Figure 5 & 7].
NOTE:
The paraffin Wax [
J
] will remain
in place and clean, however, the Wax
may wear off over time depending on
use. It is recommended to save your
Wax Block in a safe place for future use.
A
J
[Figure 7]
K
[Figure 5]
[Figure 6]
STEP 5
Install Female Tubes [
K
] over the waxed Flat Pipe [
A
] tubes
[Figure 9].
NOTE:
The holes of both Female Tubes [
K
] should align with the
holes on the FlatPipe Spine [
A
] tubes [Figure 9].
A
K
[Figure 9]
STEP 4
Insert the remaining Spring Nut [
G
] into either open end (user choice) of the
FlatPipe Spine [
A
] tubes.
Align the Spring Nut [
G
] threading with the hole at the end of the FlatPipe
Spine [
A
] tube in the same manor as STEP 1 [Figure 8].
NOTE:
Placement of the Spring Nut [
G
] is left to user discretion for either
left handed or right handed use. The user may place the Spring Nut in either
side of the Flat Pipe Spine tubes [
A
].
A
G
[Figure 8]
