Lenel OnGuard 2013, Руководство по установке

Страница: 31 / 51

NGP Keypad Installation Guide
revision 1.007 —
31
6 Programming the System Using the LCD Keypad
6.1 LCD Keypad
When the system is first powered, the LCD keypad will display that its communications are lost
(
ComsLost
). The number to the right of this comment is the keypad's unique serial address.
Note: An LCD keypad is the only module that will always display its address when it is first
powered. This is the address number that is programmed into the system for it to identify any
module. Any module will have its unique address written on a sticker on its circuit board.
To the right of the keypad's serial number are left and right arrows. These represent the left and right arrow
keys lower down on the keypad. These arrow keys are used to browse through menus. If the arrow keys are
pressed in this screen, the following will display:
• Type of keypad
• Available voltage, e.g.,
13.135 V
• Panel firmware version, e.g.,
V1.3
The next line of information will ask that the default log on code 24822 be entered to log on to the system.
After this number has been entered, the screens will start rotating with different messages. One will state
Prog-Lost!
for program lost because the system presently has no program. Another serial number will
appear next to that comment, e.g., 07132. This is the serial number of the main control board. If this number
is not marked on the board, mark it down to be used later.