Lenel OnGuard 2013, Руководство по установке

Страница: 18 / 51

Hardware Components
18 —
revision 1.007
2 LCD Keypad Notes
The LCD keypad can be connected to the NGP controller and used for programming. Please refer to the
NGP Hardware Installation Guide 55-60000E for instructions.
2.1 When a Keypad Is First Powered
When a keypad is first powered, it will display
ComsLost #
, for example,
ComsLost 50624
. The
keypad's module bus communications are not on line and the keypad's module bus, unique serial number (#)
is displayed for programming into the system. For more information, please refer to
LCD Keypad on
page 31.
The left and right arrow keys in the upper right screen corner refer to the left and right arrow keypad buttons.
They can be pressed to display the following:
• The keypad version
• The module bus voltage, e.g.,
13.054V
• Keypad firmware version, e.g.,
V0.6
2.2 Main Test Menu Selections
Using a keypad that has just been powered and not programmed into module programming, press any
number key five (5) times to display the
Main Test Menu
. This screen will also display the current
module bus power.
• Keypad tone volume adjustment:
Use the left and right arrow keys to indicate the various levels, visually and audibly. Press
SAVE to save
the setting or RST to return the volume setting to the factory default.
• PRESS KEY
This selection allows you to press keypad keys and ensure they are working properly by seeing their
alpha/numerical value appear on the screen, hearing a keypad tone, and seeing the keypad red and
yellow lights turn on or off after each key pressed.
•
CARD
This menu selection will display a card's number and if the card is ok or not when a card is held to the
keypad.
Pressing the keypad f key five (5) times for keypad serial number
After a keypad has been logged on to from the
ComsLost
screen using, for example, the service user's
code, e.g., 2482, or programmed into the system, or while being programmed in the Module Programming
Section, press the
f
keypad key five (5) times. This will cause the screen to display the type of keypad and
the keypad's serial number.