21
10. Settings and functions of the UNIFLOOR 500 software
10.1 Setting the parameter units
10.2 Setting the welding parameters
• Hold down the
Drive “On/Off” (30)
and
Heating “On/Off” (31)
buttons and
connect the power cord to the mains. "UNIT" then appears on the display.
• Press the
Select and confirm button (33)
to confirm and set the desired units
using the
Plus/Minus buttons (32)
.
• Press the
Select and confirm button (33)
to confirm and use the
Minus/Plus
buttons (32)
to select "SAVE". Press the
Select and confirm button (33) to
confirm;
the units are then saved.
The device then restarts automatically.
The units for the welding speed and for the temperature can be adjusted.
Temperature:
°C
or
°F
Speed:
m
min
or
ft
min
You can regulate the setpoints of the three welding parameters individually, even during operation.
During operation, the selected range switches automatically after 5 seconds back to the welding speed row.
Select:
Select the desired setpoint for drive, temperature or air with the
Select and confirm
button (31).
Representation:
The selected area is indicated by a bar at the side
Setting:
Use the
Plus/Minus buttons (32)
to adjust the selected setpoint to match your
requirements.
Proceed as follows:
