17
7.6 Switching off the device/Maintenance
Switch off the heating with the
Heating “On/Off” button (31)
.
Finishing welding
Wall switch (16)
• In case of contact with the wall or other obstacles, the drive is stopped and the hot-air blower is automatically
swiveled to the rest position.
Drive “On/Off” button (30)
• The welding process
is also stopped by pressing the Drive "On/Off" button (30)
. The hot-air blower is
automatically swiveled to the rest position.
If no button is pressed 1.5 minutes after the end of the welding, the air volume is automatically reduced to 45%.
During the next welding process, the air volume is increased back to the previously set value.
• Wait until the device has cooled down.
• Check the
power cord (1)
and plug for electrical and/or mechanical damage.
• Clean the
welding nozzle (6)
with a wire brush (available as an option).
After finishing the welding work, switch off the heating with the
Heating “On/Off”
button (31)
.
• The device switches to cool down mode.
• The blower switches off automatically after approx. 6 minutes.
• Then disconnect the
power cord (1)
from the mains.
