Leica DMI6000 B, Руководство по эксплуатации

Страница: 82 / 103

82
8. Operation
8.5 Focusing
Note:
The parfocality teach-in has already been per-
formed at the factory. However, it may be neces-
sary to perform another teach-in after installing
the objectives when setting the microscope up.
We recommend checking parfocality before set-
ting the stops and performing a teach-in with the
Leica Application Suite (LAS) if necessary.
Focusing the Image
The focusing is controlled by the knobs (116.3,
p. 88) on the SmartMove remote control module.
Alternatively, use the focus wheels on either
side of the stand.
The current Z position is shown on the Leica-
Screen. In the case of motorized stages, the Z
drive will travel to its lowest position prior to the
stage initialization when switching the micro-
scope on.
The focus buttons Z
″
and Z

on the right side of
the stand (Fig. 114) permit fast focusing or low-
ering of the objectives.
Setting Stops
Set the lower focus stop by pressing and holding
the
SET button and pressing the Z

button as
well.
The display will show .
Pressing the button combination again will de-
lete the stop.
The display will show .
The lower focus stop can also be set using the
Leica Application Suite (LAS).
The
lower stop is the same for all objectives and
cannot be traversed.
In addition, a focus position that cannot be tra-
versed can also be set.
To do so, press and hold the
SET button and
press the Z
″
button as well.
The display will show .
Pressing the button combination again will de-
lete the stop.
The display will show .
The focus position can also be set using the Lei-
ca Application Suite (LAS).
Set the focus position for the dry objective at the
highest magnification. The focus positions will
then be set automatically for all other objec-
tives, taking parfocality and working distances
into account.
Set the stops via
Fixed function buttons on stand
Leica Application Suite (LAS).
Summary of pictograms
Fig. 114
1
Focus control buttons
1