Leica Geosystems iCON grade iGG Series, Руководство по установке

Страница: 66 / 93

66 iCON grade, Calibrating the System
3.7 Installation and Configuration of MLB1300 Lightbars
How to install /
configure the light-
bars 1. Enter Tech Mode ( and ).
2. Enter Sensor Config Menu / Lightbar / Lightbar Config .
3. Attach one lightbar only to CAN Cross Junction Box.
• Press the centre of the MENU button ( ).
Searching for lightbar will appear.
• Select which side lightbar will be located ( Left , Right , Side ) using
the quick keys.
• Press the centre of the MENU button ( ) to complete configura-
tion.
4. Repeat Step 3 for every additional lightbar.
5. When all lightbars have been programmed, connect all lightbars,
select ESC and go to the next menu Lightbar status .
Use the quick keys to verify correct programming.
Only one lightbar should flash for each side.

MLB1300 Installation Note: For Sideshift the lightbar needs to be
mounted with the cable on the right to ensure proper guidance.

MLB1300 User Note: When lightbars are used in 3D with 3D Height or 3D
cross selected as sensors, the lightbars will only show cut/fill values on
those sides.
Numerical Values are disabled when 3D is in use.
In 3D, it is the "upper - and lower tolerances" from within the 3D system
that control when the lightbars show green.