USER INSTRUCTIONS
13
Pairing a new handset if pairing broken
Breaking a pairing on handset
To reset the handset to factory conditions (to enable the handset to be paired again with the same or another fire
for example), hold handset to unlock, press and hold pressed for at least 10-20 seconds the SET button. The
green and red lights will start to flash . They will flash for 1 minute and during this minute if you want to reset the
handset, open the battery box and remove a battery for a few seconds. Replace the battery and cover, the
handset will now be reset and ready to pair as a new handset to another (or the same) fire as shown in pairing
section.
To make a pairing
If not already fitted with batteries, remove the back panel and insert two AA Alkaline batteries in the direction
shown by the symbols moulded into the compartment and replace the cover.
Hold the handset with one hand ensuring your hand is wrapped around the back and that your hand is in contact
with both sides of the handset. The green light of the “Unlock” symbol should light and flash continuously.
The flashing indicates that it is not paired with anything at the moment and is ready to be paired.
Put the handset down within 1 metre of the Fire that you wish to pair the handset with.
Press the
+
and
–
buttons on the Fire Control (i.e. not the
+
and
–
buttons on the handset), until the red light
comes on the control and immediately press the power button on the control to initiate the pairing request.
(there is a 2 second time window to press the power button from the first red light flash. If this time window is
missed, the pairing operation is cancelled).
The handset should make a noise and the green “Unlock” light should be flashing even without holding the
handset.
The handset has received a pairing request and to accept this pick up the handset and hold as described above
to keep the keypad unlocked and press and hold the “SET” button for 3 seconds.
You will hear a beep and now the handset is paired to the fire control. The unlock green light will stay
permanently lit and steady when holding the handset.
Pairing is complete.
