USER INSTRUCTIONS
12
Starting the fire using the remote handset
By holding the handset, the green unlock light should illuminate.
With the other hand Press and keep pressed the power button continuously until the red Activity light
illuminates next to the symbol (this takes typically 1-2 seconds). As the red light illuminates release the
power button immediately. While the burner is lighting the red light will flash. When the burner has lit the red light
will stop completely. The burner will be at maximum burner rate when first lit.
You may now put the handset down or regulate the burner by pressing the
+
and
–
buttons. No buttons will
operate on the handset without the handset being held as described and the unlock feature activated.
Note: If the power button is pressed differently to the above i.e. pressed for too long or too short a time or the
grip on the handset is not firm or released too soon, the Ignition will be interrupted and not complete. The reason
for the remote control having this strict start sequence is for safety reason so that the starting operation of the
fire will be most unlikely to be done other than intentionally by an adult. If not done correctly , wait a few seconds
and try again.
Burner regulation
When the burner is in operation, hold the handset as described above to unlock the keypad and then press and
release the
+
and
–
buttons to regulate the flame of the burner. Pressing and releasing the button will move the
burner one step at a time. Pressing the button continuously will move the burner rate to the maximum full when
pressing
+
or minimum burner power if pressing
-
.
Stopping the burner
Pick up and hold the handset as described above to unlock the keypad.
Press and then release the power button once. The handset will beep and the burner will stop.
Paging the handset
If you have misplaced the handset you can page it by pressing the
+
button only on the fire control for around 5
seconds. The handset will make a noise to help you to locate it. Once you pick up the TESC it knows you hold it
and so the sound stops. The flashing and sound will last for 60 seconds each time the handset is paged as
described. If not found in 60 seconds, page again and so on. NOTE: PRESS “
+
” Button ONLY , NOT “
+
” and “
-
”
Together as you will accidentally break the handset pairing and have to reset handset to factory state and pair
again (see page 13).
AUX
SET
Power button – for On/Off of burner
Increase burner power
Decrease burner power
Activity Light – flashes red when
starting and stopping burner only.
Illuminates when key pad is unlocked
Button not used for operation
Not used
Fig. 11
