Lazer Safe LS-CS-M-069, Руководство по эксплуатации

Страница: 26 / 55

Defender Press Brake Guarding System Operation Manual LS-CS-M-069
Page 19
Original Language Version: 1.04 Released: 01/04/2020
5.2 Error Reset Indicator and Reset Button
Aside from the User Interface Panel the Defender system requires an external error reset
lamp to indicate that an error or fault condition has occurred, and an error reset switch that is
pressed to clear the error. These are typically combined into an illuminated pushbutton that
is mounted on the side or rear of the press brake.
The reset indicator can be in one of three states:
•
OFF . System status is normal
– no error, no action is required.
•
ON . An error has occurred
– press the reset button once.
•
ON/FLASHING . Multiple errors have occurred, press the reset button twice.
If the error cannot be cleared by pressing the reset button multiple times, then a fault or
emergency stop condition has occurred that must be corrected before the error can be
cleared. See the Status and Action screens of the Defender User Interface for further
information.
If the error cannot be cleared contact your supplier or Lazer Safe Customer Support for
assistance.
5.3 Optional Indicators
There are two optional indicators that may be installed with your Defender system, which
allow operators to see the state of the optical protection even when they are away from the
User Interface.
•
Mute Lamp. This turns ON whenever the optical protection is muted, and
ON/FLASHING in Tray/Tray 2 mode.
•
Obstruction Lamp. This turns ON when the optical protection is obstructed.
5.4 The Main Screen
The Main screen is the top level screen of the Defender User Interface Panel, and is shown
in
Figure 5-3 . The screen is divided into four windows; The Status, Action, Button Labels and
Sensor windows.
MENU
MODE
SELECT
TOOL
SETUP
SET INFO
ACTION PRESS FOOT PEDAL
OVERRUN TEST
0000
A
STATUS
STD
:
Figure 5-3: The Defender Main Screen
Note:
If the Defender system is idle (no button or foot pedal press) for more than 5
minutes it will display an idle screen. A button or foot pedal press will return the
panel to the most recently displayed screen.