5
A STEELFORT PRODUCT
•
Always hold the brush cutter with two hands
•
Always use the harness when operating, adjust
the length of the harness to ensure it is suitable
for operation.
•
Always use the correct blade and spool
recommended by the manufacturer.
•
Always ensure that the ventilation openings are
kept clear of debris.
•
Perform inspection before use and after any fall
or other impact to identify significant defects.
•
Rest frequently and change working positions.
Keep balance position during operation, use the
harness.
WARNING
It has been reported that, for some people, the
vibrations produced by the motorized hand tools can
lead to develop a disease called Raynaud’s syndrome
or white finger. Symptoms may include tingling,
numbness and blanching of the fingers, usually
caused by exposure to cold. There is currently no
evidence that a certain type of vibration or exposure
actually contributes to the development of this
assignment. Some measures that can reduce the
effects of vibration, can be taken by the operator:
•
Keep your body warm in cold weather. During
use, wear gloves to keep your hands and wrists
warm. It has been reported that cold weather is
one of the main causes of Raynaud’s Syndrome.
•
After each period of operation, exercise to
increase circulation.
•
Take frequent breaks. Limit the duration of
daily exposure.
•
Keep the tool well maintained, all fasteners
tightened and worn parts replaced.
•
In case of occurrence of one or more of the
symptoms described above, stop using the tool
and seek medical attention.
•
GETTING STARTED
The brush cutter is a high-speed and fast cutting
power tool. All safety precaution must be
observed to reduce the risk of personal injury. Please
read this manual carefully and become familiar with
the controls before using the unit.
ASSEMBLY
When assembling this machine, please follow the
instructions for assembly printed.
INSTALL THE MAIN BODY
Connect the engine (A) to the tube (B) with four
screws (C).
ASSEMBLY OF THE HANDLE
(FIG.1-1,1-2,1-3)
1.
Remove the screws infixing device and remove
the upper cover. (Fig.1-1)
2.
Place the handle in position and assemble the
upper cover. (Fig.1-2)
3.
Assemble and tighten the screw. (Fig.1-3)
FIG.1-1
FIG.1-2
FIG.1-3
