ONLINE MANUAL
Scan this QR Code with your
mobile device to take you to
the online manual.
1. Main Handle
2. On/Off Switch
3. Lock Off Switch
4. Lower Blade Guard
5. Blades
6. Upper Blade Guard
7. Side Handle
8. Wax Feeder Knob
TWIN CUTTER
KNOW YOUR PRODUCT
TCS-6100
1. SIDE HANDLE
3. CUTTING WOOD
4. CUTTING METAL
Always use the wax lubricating system when cutting aluminium,
copper, stainless steel sheet and cast iron up to 3mm thick.
1. Raise the lower guard
and keep it raised with
the thumb of your left
hand whilst gripping the
side handle.
4. Turn the wax feeder
wheel ¼ turn.
1. Remove the end caps from
a wax stick.
2. Fully insert the wax stick
into the holder.
1. Securely clamp the workpiece.
OPERATION
The tool is recommended for use with a residual current device
with a rated residual current of 30mA or less.
1. Turn on the Twin Cutter.
2. Hold the saw so that the blades are perpendicular to the
workpiece.
3. Tilt the saw upwards so that
it is angled at approximately
30°, keeping the blade
perpendicular to the plane of
the workpiece.
4. Move the blades along the cutting line. Do not use excessive
force. Allow the Twin Cutterv to do the work.
CAUTION:
ALLOW THE BLADE TO REACH
FULL SPEED BEFORE CUTTING. OTHERWISE
“KICKBACK” MAY RESULT, CAUSING SERIOUS
INjURY.
CAUTION:
WHEN YOU RELEASE THE ON/OFF
SWITCH, ALLOW THE BLADES TO COME TO A
COMPLETE STOP.
2. Switch on, allow the blades to reach full speed and then
plunge the blades into the workpiece.
1. Unplug the Twin Cutter and allow the blades to cool.
1. Place Blade A onto the blade flange with the pins of the flange in
the corresponding holes in the blade.
2. Rotate the blades independently until the holes in both
blades are aligned.
3. Place the lock pin attached
to the wrench through the
holes to lock the blades.
4. Unscrew the lock nut and
remove it.
5. Retract the lower blade
guard.
6. Remove “Blade B” and then “Blade A”.
2. Place Blade B over
the shaft.
3. Screw in the blade bolt but do not tighten.
4. Turn the blades so that the holes are aligned.
5. Place the lock pin
through the holes
to hold the blades.
Tighten the lock nut.
SETUP & PREPARATION
1. Attach the side handle to the twin cut saw
Side Handle
Preparing your workpiece
2. Mark your cutting line.
NOTE:
The kerf (width of cut) is 4.5mm. Allow for this when making
a cut.
2. ON/OFF SWITCH
1. To turn the saw on, depress the lock off switch then the on/off
switch.
a
b
2. To turn the saw off, release the on/off switch.
5. Follow the instructions for cutting wood.
5. REMOVING BLADES
PLUNGE CUTTING
9. Wrench
11. Wax Sticks
10. Locking Pin
6. Turn the blades by hand to check that they easily turn in
opposite directions.
6. FITTING BLADES
WARNING:
Always ensure that the lower guard is releasing
freely and is fully cloesd before commencing work. If it
is binding or sticking do not proceed and contact Ozito
Customer Service.
Caution:
The Twin Cutter is not designed to be used with abrasive
wheels.
