12
A STEELFORT PRODUCT
1.
Press the fuel pump several times until it fills
with fuel. (Fig.12)
2.
Turn the engine switch to the ”I “position.
(Fig.13) Press the throttle trigger, throttle
trigger lockout and lock pin together to lock the
trigger .
WARNING
the switch is auto-returned switch, it would always
stays in “I” position, press it to “O” manually if needed.
3.
In Res.13, Press the trigger lock to activate the
trigger, then press the trigger lock pin together
to make the trigger half open. This is for easier
starting.
4.
Move the choke lever to position. (Fig.14)
5.
Close the choke: Start Position
WARNING
Ensure the cutting attachment stops when the engine
is idling. Note that initial engine startup may require
multiple attempts for the fuel to reach the motor.
6.
Turn the choke lever to the run position. (Fig.16)
7.
Pull the starter quickly until the engine starts.
8.
Press the trigger (in Res.13) to release the
trigger lock pin.
9.
After starting, let the engine run for 2 to 3
minutes before subjecting it to any load.
HOT START
When the machine is hot, keep the choke level in
“Start position”, the user can start the machine by
repeating steps of 1,2,6,7.
WARNING
Under the following conditions the machine MUST be
stopped.
•
When the motor rotary speed changes
•
When sparks occur
•
When blades are damaged
•
In case of misfire
•
In case of high vibration
•
When flames or smoke appear
•
In rain or stormy weather
Check the cutting attachment always stops when the
engine is idling.
FITTING THE FULL VEST HARNESS
(FIG.17)
FIG.12
FIG.13
FIG.14
FIG.15
FIG.16
