6
A STEELFORT PRODUCT
CONNECT THE TROTTLE CABLE AND STOP SWITCH
WIRES
1.
Remove the air filter cover
2.
Install the throttle cable (A) through the
carburettor bracket (B)
3.
Turn the cable adjuster sleeve (C) into the
carburettor bracket fully
4.
Put the slot fitting (D) on the carburettor. At this
time the recessed hole (E) throttle cable plug
(F) is away from the cable adjuster sleeve (C)
5.
Rotate the carburettor throttle cam and move
the throttle cable (A) through the slot in the slot
fitting.
6.
Make sure the cable lug (F) drops into the
recessed hole.
7.
Operate the throttle trigger some times to make
sure that it operates correctly.
8.
Adjust the cable adjuster sleeve (C).
9.
Make sure the stop on the carburettor throttle
cam touches the throttle stop correctly.
10.
Make sure the cable position keeps 1-2 mm
between cable lug (F) and slot fitting when the
throttle trigger is fully pushed.
11. When the throttle cable (A) is adjusted correctly,
tighten the lock nut (G).
12. Connect the stop switch wires (H) with the
connectors from the engine.
13. Install the air filter cover.
WARNING
Do not tighten the screws until you have set the
handle in optimal working position. Please always
adjust the handle position with full assembled
accessories. The black cable tie can be used to fix
the throttle cable to the metal tube. (Fig.2)
ASSEMBLE THE GUARD
(FIG.3-1, FIG.3-2)
1.
Place the guard on the fixture. (Fig3-1)
2.
Assemble and tighten the screws. (Fig.3-2)
WARNING
When using the cutting line head, the additional
guard, with line cutting knife, must always be fitted.
(Fig.3-3,Fig.3-4)
Secure the additional guard (26) using the screw (B).
(Fig.3-3)
FIG.3-1
FIG.3-2
FIG.3-3
