8
A STEELFORT PRODUCT
REPLACING LINE
1.
Unclip the housing from the line trimmer and
remove spool from the spindle.
2.
Remove all remaining cutting line from the
spool.
3.
Cut 2m of line. Fold in half and attach the mid-
dle of the line into the grove/slot located in the
center of the spool.
4.
Wind both sides of the line on to the
spool with tension in the same direction as
shown on the inside of the spool. (See above
right image)
5.
Continue to wind the line until you have 150mm
of line left on each end. Note: It is helpful to
clip and fasten the line on opposite ends of the
spool to keep the line from unraveling during
the next step.
6.
Put the spool into housing. Unclip the line from
the spool and place line through the open eyelet
on opposite ends of the housing. Ensure the line
has not tangled.
7. Clip the housing back onto the line trimmer
