lavina 32R-S-E, Руководство пользователя

Страница: 11 / 33

Superabrasive Owner’s Manual Original Language – Lavina
®
32R-S-E 11/2014
12
OPERATING THE MACHINE
Guide the machine in straight lines across the floor, and with each new line overlap a little bit of the previously completed
surface. Work at a constant speed allowing the tools time to work at a speed appropriate for the tools’ grit size. Avoid
vibrations. Do not stop the machine in one spot while the tools are still working because they will leave marks on the floor
surface. When working wet, begin with the water tap, (Fig.4.2-1) position for the water feed and periodically start the pump
(Fig 4.12-11) to release water onto the floor surface. Starting the pump is only possible if the machine motor is on. When
working dry, check the floor surface periodically to ensure that dust is not accumulating on it. Regularly check to make
sure the vacuum works properly. In any case you may turn on the lights (Fig.4.12-5).
STOPPING THE MACHINE
The machine can stop by switching the joystick in opposite position of the moving direction.
The movement of the machine should only be stopped then the motor has completely stopped. Do not stop moving the
machine before stopping the motor rotation, otherwise it could damage the surface.
In order to stop the machine’s motor, use the “motor off” switch (Fig.4.12-1). Only use the “Emergency stop button” in an
emergency!
NOTE! Do not hold the machine in one spot until the motor completely stops turning!
ALARM
The machine stops when the emergency stop button is activated or the inverters are shut down by emergency. It
is indicated by a flickering lamp built into the switch “BATTERY-LINE".
The control panel display will show "
Emergency stop " or " Inverter fault ". After eliminating the accident, reset the
machine by releasing the emergency stop or turning on the "Inverter reset" ( Fig.4.12-3).
5.TOOLS AND ACCESSORIES
WEIGHTS
Superabrasive offers additional weights for increasing
the productivity of the machine (Fig.5.1). Each additional
weight weighs about 64 lbs or 29 kg. The number of
weights you choose to use will vary from none to two.
Each individual application, type and condition of
surface, power capacity of the outlet, etc. will determine
the number of weights you can use without tripping a
breaker. The first weight stacks onto the posts on the
frame around the outer bowl (Fig.5.2)
. The second
weight stacks onto the first.
The additional weights depend on the tools; it is not always possible to add weights. Some tools work too aggressively
and the machine can stop. Additional weights can be ordered with item number A08.00.00.00
TOOL HOLDER KEY
The tool holder key (Fig. 5.3) is used for adjusting, mounting, and dismounting the tools.
Always use the key for mounting. Item number is A03.00.00.00
FOAM PLATE
Diamond tools with Velcro are mounted on the 9” foam plate (Fig.5.4). The foam plate is
mounted on the flexible backer plate. Item number is LV-9-FP-S
SECURITY PLATE FOR QUICKCHANGE PADS
Plate (Fig.5.5) is used to secure the “QuickChange” pads.
Item number is A38.00.01
Figure 5.3
Figure 5.4
Figure 5.5
Figure 5.1 Figure 5.2