lavina 32R-S-E, Руководство пользователя

Страница: 21 / 33

Superabrasive Owner’s Manual Original Language – Lavina
®
32R-S-E 11/2014
22
9.3 TENSIONING USED PLANETARY BELT
Take the main head of the carriage, like described in the
paragraph “Splitting the carriage from the main head”,
Dismount the top cover.
Noticing speed lost in planetary movement it is possible to
tension the belt for planetary movement as described
in 9.4 Mounting and tensioning a new planetary belt.
9.4 MOUNTING AND TENSIONING A NEW PLANETARY
BELT
Dismount completely the
tensioning device.
Make 2 signs on the
dismounted belt exactly 10
cm out of each other (belt
without tension) (Fig.9.4.1).
The purpose is to measure
10.2 cm on the belt.
ATTENTION: NEVER
“OVER” TENSION THE
BELT, THE BELT WILL BE
DAMAGED AND IT WILL
NEVER RECOVER ITS
ORIGINAL TENSION
Mount the belt back around
the planetary pulley; see that
the belt is behind the driving
pulley (Fig.9.4.2). Put the
belt around the left roller of
the tensioning device
(Fig.9.4.3). Put the
tensioning device back in
place and pull the belt from
the roller on the right side
(Fig.9.4.4). Put the belt
around the driving pulley
(Fig.9.4.5).Slightly loosen
the two bolts of the
tensioning device (Fig.9.4.6) (Fig.9.4.7).Begin to tension until the measure of 10 cm between the marks becomes 10.2
cm (Fig.9.4.9. Tighten the tensioning device while turning the bolt move the planetary head so the belt can slide.
(Fig.9.4.9). Do not forget to lock the tensioning device.
9.5 TENSIONING AND REPLACING THE BELTS
PLEASE MAKE SURE YOU CHECK THE TENSION OF THE BELT AFTER THE FIRST 15 HOURS OF OPERATION
To check the
tension of the
belts: Open the
small bottom
cover (Fig.9.5.1).
Check the two
belts tension, it is
recommended
that you use an
Figure 9.5.2
Figure 9.5.3
Figure 9.5.1
Figure 9.4.6 Figure 9.4.5 Figure 9.4.7
Figure 9.4.9 Figure 9.4.8 Figure 9.4.10
Figure 9.4.3 Figure 9.4.2 Figure 9.4.4
Figure 9.3