lavina 32R-S-E, Руководство пользователя

Страница: 9 / 33

Superabrasive Owner’s Manual Original Language – Lavina
®
32R-S-E 11/2014
10
4.OPERATION
PRELIMINARY CONTROLS
Inspect the working area as explained in the safety instructions. For wet use, fill in the water tank when the electrical cable is
disconnected. Connect the vacuum extractor and ensure that the vacuum hose is clear and it will follow the machine easily. Plug
in the machine and make sure that the power cord is free to follow the working direction of the
Lavina® 32R-S/32R-S-HV.
CONTROL OF THE WATERFLOW
The operator can choose the water sprays with valve
(Fig.4.2 1)in the front (fig.4.1) when the level of the tap is in
the vertical position , when the level is in the horizontal
position water will spray under cover of the machine.
The valve (Fig. 4.2 2) is controlling the flow of
an external water supply. A ¾” water tube can be attached
to the quick connection (Fig. 4.2 3).
ADJUSTING AND MOUNTING TOOLS
Mount the tools only after ensuring that there is enough
diamond bond material left. Be sure that the plates are always
clean before mounting.
WARNING: Always secure the
“QuickChange” pads with the security plate (Fig.4.3), lock with
the tool holder key (Fig.5.3). Diamond tools with Velcro are
attached on six 9in foam pads (Fig.4.4). The foam plates are
mounted on the key lock (butterfly). Always use the tool holder
key (Fig.5.3).
FRAME BLOCKING (U-JOINT]
The frame holds the working head and the trolley together
(U-Joint), which allows rotation of the two perpendicular
axes to better follow the profile of the floor.
The movement around one of axis can be blocked with
two screws to the plank, mounted on the front of the frame
(Fig.4.5). Unscrew the bolts and turn the plank so it fixes
the frame to the carrier with its tooth and then tighten the
bolts (Fig.4.6). Thus the lateral movement of the machine is
blocked.
CONTROL PANEL
The Control Panel can work while connected to the machine or as a remote control device.
When it is connected to the machine it has to be supported by the handle bar, with the transmitter panel located below.
Unscrew the protective cover of the panel (Fig.4.8), and then unscrew the nut of the plug (connecting the cable to the
transmitter) and connect the plug to the panel (fig 4.10). Put the protective cover back on the transmitter (fig 4.11).
When the panel is working as a remote control device the cable should be connected to the transmitter.
Figure 4.4
Figure 4.3
Figure 4.5 Figure 4.6
Figure 4.1 Figure 4.2
Figure 4.8 Figure 4.9 Figure 4.10 Figure 4.11