Launch X-712, Руководство пользователя

Страница: 27 / 37

LAUNCH X-712 Wheel Aligner Operation Instructions
4-10
instrument now. The corresponding [Operator] can be
selected only after the [Operator] column of [Information
for service station] is added (Please refer to [System
management] – [User information]).
[Fault cause]: The symptoms of the vehicle under test.
There are 5 options: [Tire wear], [Pull], [Steering wheel
is not centered], [Steering wheel swings] and [Others].
[Return to caster swing]: If you are not satisfied with the
measurement results, you can click this button to return
to the interface of [Caster Swing] to perform the
measurement operation again.
[Print/Save]: To print the alignment data of the vehicle
under test in the format of form or image (Please refer to
[System management] – [Report setting] for the format
setting of the report form); To save the alignment data of
the vehicle under test ([Vehicle plate number] and [Client
name] must be entered, and [Fault cause] must be
selected first before saving).
Caution: The report form print function provided by this
interface only aims at the individual information report
form for the test at this time; the report form print
function provided by the main interface aims at all the
information report forms saved and done before.
Quick Measurement
Select [Quick measurement] icon on the main menu, the
system will enter the [Quick measurement] interface.
This interface provides an operating platform for quick
measurement, which can test and display toe-in and
camber of front and rear wheels at the same time. The
interface is as shown in the following figure:
Fig.4.33
[Select Vehicle Model]: You can select the parameters of
standard vehicle models to be convenient for vehicle
adjustment (Please refer to [Standard
Measurement]-[Select Vehicle Model]);
[Print Report]: To provide the functions for saving and
printing the test data (Please refer to [Standard
Measurement]-[Print Report]).
Note:
1. This interface provides only the functions of the
test and adjustment for front and rear toe-in and
camber. For other functions, please select them
on the interface of [Standard Measurement].
2. The default unit for toe-in on this interface is
centigrade. The display unit for toe-in is in
accordance with the toe-in unit set on the
interface of System Management]-[System
Setting].
3. If the alignment parameters are required to be
adjusted at the calibration position, firstly
please perform the alignment test at the
calibration position, and then lift the vehicle up
to the desired position to perform the alignment
parameter adjustment operation after the tested
data is stable.
Additional Measurement
This interface provides an operating platform for special
measurement, which can measure and display left
lateral offset, right lateral offset, axle offset, front setback,
rear setback, track width difference and wheelbase
difference, etc. The interface is as shown in Fig.4.34.
Fig.4.34
[Select Vehicle Model]: Click this button to select the
parameters of standard vehicle model. If the parameter
values of wheelbase and front/rear track width are
contained in the standard database, each angle value
displayed on the screen will automatically be converted
into length value with the unit of mm.
[Chassis measurement]: Click this button
，
the interface
is as shown in Fig.4.35.
Select Vehicle Model
Image format
Print report
Select Vehicle Model
Chassis measurement