LAUMETRIS MKL, Руководство пользователя

Страница: 51 / 57

USER MANUAL Manure spreader MKL 51
8. TROUBLESHOOTING
Item No Problem Cause Solution
1. The brake drum
heats up Improperly adjusted brake blocks Adjust according to Section 7.2.2
2. The wheel hub
heats up
Do not apply too much power
when working on the ladder
Contaminated bearing lubricant Adjust according to Section 7.1 Disassemble the
hub, replace the lubricant, and adjust as
indicated above
3. Lubricant falls on
the brake blocks Damaged, worn-out or improperly
installed hub seal Disassemble the hub and properly replace the
seal. Remove lubricant from the brake blocks
and drum and clean them with gasoline.
Assemble the hub and adjust as indicated above
4. Wheels brake not
uniformly Worn-out, contaminated or
improperly adjusted brake blocks
Replace worn-out blocks, clean contaminated
ones, and adjust according to Section 7.2.2
5. Wheels brake
weakly
Improperly adjusted brake blocks
and brake elements Adjust according to Section 7.2.2
6. Lubricant on the
hoses
or
connections of the
hydraulic system
Insufficiently tightened
connections or damaged hoses
Tighten up or replace the parts
7. Lubricant on the
hydraulic cylinder Damaged spacers of the hydraulic
cylinder or bent cylinder Replace the spacers the cylinder with new ones
Table 8.1. Possible problems and ways of elimination.
9. PERIODICAL SERVICING
9.1 Lubrication
Lubrication is one of the most important factors determining the durability of separate assemblies and
mechanisms. Timely lubrication and application of appropriate lubricants considerably decreases the early
wear and possibility of the occurrence of failures. Lubricate the manure spreader in compliance with the
following principles:
•
before applying lubricant to a lubrication point, clean it;
•
squeeze lubricant into the lubrication point until used old lubricant appears;
•
after lubrication, leave a small amount of lubricant on the head of the lubrication point.
Apply lubricant in accordance with the presented diagram (Figure 9.1, 9.2 and Table 9.1).
Lubrication
point No. Lubrication point location Lubricant Lubricant base Lubrication
frequency
1 Towing loop Litol 24 Li Once a year
2 Variable-height support foot Litol-24 Li Once a year
3 Brake cam shaft Litol-24 Li Once a year
4 Brake lever Litol-24 Li Once a year
5 Drive shaft bearing Litol-24 Li Once a year
6 Hydraulic cylinder head Litol-24 Li Once a year
7 Wheel hub and springs Litol-24 Li Once a year
8 PTO shaft Litol-24 Li Once a year
9 Hand-brake Litol-24 Li Once a year
10 Chain transporter sprockets Litol-24 Li Once a year
11 Chain transporter driving shaft bearing Litol-24 Li Once a year
12 Manure spreader bearings Litol-24 Li Once a year
13 Chain transporter tensioning shaft bearing Litol-24 Li Once a year
Table 9.1. Lubrication table.