
4
LatticeMico32/DSP Development Board
Lattice Semiconductor
User’s Guide
Figure 1. LatticeMico32/DSP Development Board Block Diagram
Table 1. Board Defaults
Peripheral Interfaces
This section describes all peripheral interfaces of the LatticeMico32/DSP Development Board in alphabetical order.
Figure 2 shows the position of peripheral interfaces available on the board.
Item
Type
Default
Status
Comments
LatticeECP33
FPGA
Programmed
The bitstream is based on Example PlatformA and the
LED7SegsTest project. The LED7SegsTest.mem and
LED7SegsTest.bit files are included in the LED7SegsTest
project.
Visual indications of operation are:
• Left to Right and Right to Left scanning of the 8 LEDs.
• Upcount and roll over of the 7 segment displays from 0 to 99
decimal at ~1 second intervals.
LCD Backlight (X5)
Jumper
Open
Backlight is off.
Configuration Switch
TMS Switch
Off (Down)
LatticeECP33 device can be programmed.
Sigma Delta DAC Converter
Jumper
Open
Contrast Control
Reostat
Varible
Not set to any specific level.
4-place DIP - Logic 1
Switch
Off
Logic 0 on selected pins - see Table 18.
SODIMM DDR 400 Setting (X18)
Jumper
Shorts Pins
1 and 2
Set to below DDR400 memory use.