LaserLine LC800, Инструкция по монтажу

Страница: 61 / 68

61
USER MANUAL
POWER SUPPLY WIRE CUTTING SENSOR
( 908 or 908RF ) only for kit combined with self powered siren
With system armed, an attempt to interrupt the power supply will generate an alarm
condition for t
cycles (f seconds pause between cycles and the other); at the end en ive
of these cycles the siren will remain armed.
To stop the alarm condition, is necessary reconnect the siren and disarm the system
using the remote control.
EMERGENCY DISARMING WITH ALARM ARMED
WITH ELECTRONIC KEY (optional)
In case of breakdown of original radiocommand, its possible disarming the alarm
system via ELECTRONIC KEY.

Open the door of the drive side with mechanical key

The siren will start playing

Insert the electronic key in the receptacle

The system is permanently deactivated by entering garage mode function signalled
from 1 blink of the led every 16 second. In this condition the original radiocommand
even if repaired or the additional radio command does not activate or deactivate the
product
TOTAL DISARMING ‘’GARAGE’’
VIA ELECTRONIC KEY (optional)
In case of break down of origianl rafiocommand of the vechicle or for leav the vehicle in
assistance (GARAGE) is possible disarming completally the system of the alarm via
ELECTRONIC KEY.
-Turn on and off the dashboard two times be sure of keep the dashboard on at the
second power up.
-Insert the elctronic key in the receptacle for 3 times, indicated from a blink of the
status led.
-The siren will signalled with 3 short beep the entering in garge mode.
-The system signals the garage function with 1 blink of the led every 10 second.
Procedure for exit from the condition ‘’GARAGE /EMERGENCY’’
For restore the normal function:
Turn on the dash board and insert 3 times the electronic key in to the recpeptacle,
a short acustic signal and a blink of the LED of status incate the restore of the system.