![background image](http://html2.mh-extra.com/html/laserline/lc800/lc800_fitting-instructions-manual_4575814046.webp)
46
VEHICLE CODE PROGRAMMING
If the system must work via CAN-BUS line, the alarm system needs to be configured
according to the vehicle on which it is to be installed.
A series of vehicle codes has been loaded into each control unit.
To select the specific model, follow the procedure described here using the button on
the back of the unit.
it is always advisable to check and download the car via the PC connection, for any
improvements or updates.
If the vehicle of interest is not present in the list, it is possible to check the presence of
the software on the laserline site, via PC is possible load and select the model.
To help you unederstand the coding procedure , here below is an example illustrating
the configuration procedure. In this case the coded used is 1-0-3.
The list of available vehicles and the relative codes are shown on the additional sheet
present in the ISAUTO.
The system has an indicator LED that signals any wrong vehicle code inserted.
If the code is not a value correct, the LED on the unit blinks repeatedly and
the procedure is interrupt.
The previously inserted code remains stored.
The procedure is also invalidated if the LED blinks more than 10 times.
In this case there are no optical warnings, the procedure will simply be interrupt.
In either case, repeat the whole procedure.
Example of programming code: 1 - 0 - 3
Release the button, the LED switches OFF
Push and keep hold the button shown in figure, until the switching ON of the led
The system can operate in various modes according to the vehicle on which it is
installed and depending on the connections that can be made.
The system is enable to be manged through the CAN-BUS line and operate in
combination with the CAN signals, with the turn indicators flashes and/or the door lock
motor unit.
The system automatically manges the different arming/disarmig signals.
Consult the technical installation charts for the available connections for each vehicle.
CONNECTIONS AND MANAGEMENT BY CAN-BUS LINE
System arming/disarming and alarm causes are managed through CAN-BUS line.
Therefore only connect the alarm system CAN BUS line to the vehicle CAN line wires
diagrams.
CONNECTION MODE FOR ACTIVATE AND DEACTIVATE THE SYSTEM
WITH CAN NETWORK
USB
RED
KEEP PRESSED
RELEASE THE BUTTON
Содержание LC800
Страница 32: ...NOTE 32...
Страница 66: ...66...