LARTET DN-107P, Руководство по эксплуатации

Страница: 11 / 33

CAPÍTULO 3 INSTALACIÓN 3-1
DN-107P displays series
3. INSTALLATION
The installation of the DN-107NE is not particularly delicate but some important
considerations must be taken into account.
The display must not be anchored to places subject to vibrations, nor should it be
installed in places which generally surpass the limits specified in the display characteristics,
both in terms of temperature and humidity.
The degree of protection of displays DN-107P, is IP41, meaning that they are protected
against penetration by solid foreign objects of a diameter of about 1mm and against the vertical
fall of water droplets.
Displays DN-107P should not be installed in places with an illumination level in excess
of 1000 lux. Neither should the display be placed in direct sunlight as visibility would be lost.
In the electrical installation, proximity to lines of high intensity circulation and high
voltage lines must be avoided, as well as proximity to High Frequency generators and U/F
converters for motors.
3.1. Power supply
The power supply must be 88 to 264 VAC 47 to 63Hz or 19 to 36VDC.
The power supply conductor section will be in line with consumption and the ground
conductor will be a minimum section of 1.5mm².
The power supply connector for 220VAC has 5 contacts and is situated in the lower part
of the unit. Connect the power wires following the schema below
The power supply connector for 24VDC has 4 contacts and is situated in the lower part
of the unit. Connect the power wires following the schema below