BS250 BASE STATION SETUP
Following descriptions are stand-alone LT250 system configuration. Using additional devices such as Remote Base Station,
auxiliary input/outputs and 8ohm speaker will be explained later.
Step 1:
Put two enclosed antennas to the antenna connectors (#1 and #5) on the rear panel of the Base Station. Turn the sleeve on
each of the antenna connectors clockwise to tighten them, and ensure that the antennas are connected firmly.
NOTE 1:
These two antennas must be positioned vertically and be folded completely as 90 degree. Otherwise, it will be
caused to weaken the signal.
NOTE 2:
While attaching the antennas directly to the rear panel of the Base Station, the Base Station should be away
from any metal obstructions, walls, and electronic equipments that can create radio interference. It is highly
recommended to place the antenna as high as possible in the center of the coverage and away from
obstructions. The antenna extension cable enables an antenna to be mounted away from the Base Station to
extend coverage.
Step 2:
Plug the DC cable from the enclosed wall-adapter power supply into the 12VDC POWER connector (#9) on the rear of the
Base Station. Plug the large female connector at the end of the AC power cord into the power supply
.
Plug the other end of
the AC power cord into a standard wall outlet.
Figure 3-2. Front Panel of the Base Station
15
12
13
14
10
1
3
2
4
5
6
8
7
9
11
Figure 3-1. Rear Panel of the Base Station
1
2
3
4
5
6
7
8
9
10
17
