AUX AND AUX COMMUNICATION GROUP BUTTONS
AUX Button (#3)
With AUX button you can select three options - only auxiliary Input (AUX IN) or auxiliary Input and Output (AUX I/O) or no
use of auxiliary devices. Each mode is set by pressing AUX button sequentially. When auxiliary input is selected, AUX IN
light on top of the AUX button will be on. When you use the auxiliary input and the auxiliary output devices at the same
time, the AUX I/O can be selected. When AUX I/O is selected, AUX I/O light on top of the AUX button will be on. When
no use of auxiliary devices is selected, AUX IN and AUX I/O lights on top of the AUX button will be off.
AUX Communication Group Button (#4)
Communication Groups of the auxiliary devices is set to use
“1” (Group 1) by the factory default. Press AUX GROUP (#4)
button on the front panel of the Base Station, and select Communication Group for the auxiliary device. The
Communication Group will change from
“1” to “3”, and to “A”(All) by each pressing. The Communication Group “1” will
come again after “A”(All). Selected AUX Communication Group is displayed on the NORMAL menu of the Base Station,
as shown in Figure 4-3:
STAUS LIGHTS ON THE BASE
STATION’S FRONT PANEL
RF ALERT light (#6)
When there are audio breakups seriously for each received frames, RF ALERT light will go on.
RBS LINK light (#6)
When the Remote Base Station is connected to the network switching device, RBS LINK light will go on.
RBS ACTIVE (#7)
When the Remote Base Station exchanges data with the Base Station, RBS ACTIVE light will be flashing.
MENU CONTROL
MAIN Menu
Press SET under the NORMAL menu, the MAIN menu appears, as shown in Figure 4-4: Move to and press SET to select
on each menu, VOLUME, MONITOR, UNLATCH, BS, RBS, BELTPACK and MULTI-BS. Move to and press SET to select
QUIT or press SET for 2 seconds on any item to return to the NORMAL menu.
VOLUME Menu
Move to and press SET on VOLUME, to get into the VOLUME menu as shown in Figure 4-5. You can adjust volumes of
the Base Station‟s headset and external speaker by selecting SPEAKER. And you can adjust the microphone gain by
selecting MIC, the side tone by selecting SIDETONE
of the Base Station‟s headset, auxiliary Input and output level by
selecting AUXin and AUXout. Move to and select QUIT or press SET for 2 seconds on any item to return to the MAIN
menu.
Figure 4-4. MAIN menu
40
