Landoll EHP, Руководство оператора

Страница: 38 / 54

4-14 F-1153-2308
MAINTENANCE AND LUBRICATION
TABLE OF CONTENTS
12 Month / 500 Hour Inspection Checklist
Electric Hydraulic Power Unit
Certified Technicians: Conduct every 12 Months or 500 Hours to identify possible faults or safety concerns. It is
important that these inspections are documented. During this inspection, be sure to check the overall condition of the
equipment (i.e. body/paint damage, etc). Also check the equipment for any signs of fluid leaks. Make comments of any
conditions that are out of the ordinary and report them to your supervisor immediately.
Date Inspector Location Shift
Model Number Equipment Number Hour Meter
Inspect Description Comment or (Good, Monitor, Faulty)
Key Switch Verify the key switch is in the “OFF” position
and secure key.
Enclosure Decals &
Covers
If charging, verify the charging port light is
steady on.
If charging, remove and secure the
extension cord from the charging port and
close the weather cap.
Decals Inspect for fading, missing, wear, pealing,
signs of brittle / fatigue and visual defects.
Inspect Decals and mating surfaces for
corrosion, dirt, grease.
Hoses & Couplers Disconnect the hydraulic hoses and
couplers from the equipment couplers.
Covers Remove the top cover, front cover, vent
cover and rear cover.
Inspect for bends, burrs, cracks, dents,
wear, distortion, and visual defects.
Inspect mounting hardware for bends,
breaks, burrs, cracks, dents, wear, signs of
brittle / fatigue, tread condition and visual
defects.
Covers & Hardware Inspect for corrosion, dirt, rust, grease.
Battery Disconnect Disconnect the Negative and Positive
cables from the battery terminal buss bars.
Insulate the cable ends and place them
where they will not contact the buss bars.
Enclosure Interior &
Exterior
Remove debris and blow out dust with low
pressure air.
Wash with mild detergent and rinse with
low pressure water.
Remove grease and oil build up with
degreaser and rinse with low pressure cold
water.
Charging Port & Light Inspect for signs of wear, damage or
missing port weather cover.
Display Module Inspect the for signs of wear or damage.
Emergency Stop Push and pull the Button to check function.
Pump-On Light
(continued next page)
Inspect for signs of wear or damage