Landoll 2320F-7-30, Руководство оператора

Страница: 39 / 46

4-4 FIELD OPERATION
CAUTION
DEPTH ADJUSTMENT MUST BE
EQUAL ON ALL CYLINDERS. UNE-
QUAL DEPTH ADJUSTMENT CAN
CAUSE PERMANENT EQUIPMENT
DAMAGE.
CAUTION
HITCH MUST BE LOCKED WHEN
FOLDING OR UNFOLDING THE WING.
4-4.1 Unfold the wing. Extend the fold cylin-
ders completely to allow the wing to float.
4-4.2 Remove the hitch lock pin and using the
same hydraulic lever used to unfold the wing,
swing the hitch to field position. Replace the
hitch lock pin and safety pin.
4-4.3 Remove the transport locks from the
cylinders. Lower the Weatherproofer until
the points run at the desired depth.
4-4.4 Check the front-to-rear leveling of the
frame. Level the machine by adjusting the
hitch radius rod. Set the frame level at its
working depth.
4-4.5 Set the depth by using a combination of
cylinder stops to achieve the desired depth.
For stability, it is important that the gauge
wheels always apply slight pressure against
the soil.
4-4.6 Always lift the Weatherproofer com-
pletely out of the ground before turning or
backing. This prevents shank or disc dam-
age or damage to their respective mounting
brackets.
4-4.7 Reduce speed at field ends, and lift the
Weatherproofer completely out of the ground
before turning.
4-4.8 After a few hours of operation, check all
bolts for tightness, especially the shank U-
bolts and pivot bolts. Tighten wheel lug bolts
to 90 ft-lbs of torque. Tighten any loose bolts
to the torques shown in Tables 2-1 and 2-2 .
CAUTION
TIGHTEN ALL 1-1/2" NUTS TO 1200
FOOT-POUNDS OF TORQUE.
DANGER
DISC BLADES ARE EXTREMELY
SHARP. EXERCISE EXTREME CARE
WHEN WORKING ON OR NEAR DISC
BLADES. DO NOT ALLOW DISCS TO
ROLL OVER OR FALL ON ANY BODILY
PART. DO NOT ALLOW WRENCHES
TO SLIP WHEN WORKING NEAR DISC
BLADES AND NEVER PUSH
WRENCHES TOWARDS DISC BLADES.
DO NOT CLIMB OVER MACHINE
ABOVE DISC BLADES. FAILURE TO
STAY CLEAR OF DISC BLADE EDGES
CAN RESULT IN SERIOUS PERSONAL
INJURY OR DEATH.
4-3
Figure 4-1 1200 Foot-Pounds of Torque