Landmann 12113, Сборка и руководство по эксплуатации

Страница: 21 / 28

21 Ardor
Built in Installations
Caution:
Landmann built in grills are intended either for instal-
lation in a built in enclosure constructed of non-com-
bustible materials or for an installation in a built in
enclosure constructed of combustible material when
installed with a Landmann insulated jacket .
For non-combustible applications, the grill drops into the
opening shown in the cutout detail drawing (See Cutout
Dimensions for Built In Grills on page 22) and hangs from its
counter-top trim. A shelf is not required to support it from
the bottom.
When using the insulated jacket in a combustible enclosure,
the jacket must be supported from the bottom by a ledge
on each side or a full deck beneath the jacket.
Pay special attention to the instructions shown for gas line
hook-up.
The enclosure should have ventilation holes to prevent LP
gas build-up in the event of a leak. The deck ledges and
counter should be flat and level.
If you plan to use a rotisserie kit with your grill
then a minimum of 20 cm of clearance is nee-
ded on both sides of the grill above the coun-
ter top. For 3 Burner models an additional
15 cm (35 cm total) is required on on the side of the
grill for clearance.
Installing the Appliance in a BBQ Island
Always check with local building codes, fire inspec-
tors, neighborhood association and local contrac-
tors before constructing an island. A permit may be
required for building any outdoor kitchen.
Caution:
The island must be made out of non-combustible mate-
rials. In the event it is combustible, the use of an insu-
lated jacket is required. Minimum clearance to adjacent
combustible construction is 90 cm from sides & 90 cm
from back.
• Before installing an appliance in any island cut out, make
sure that the opening is not bigger than the outside fra-
me of the appliance. The appliance should rest on the
lip of the frame. Pay careful attention to the location
of the gas line. It should be routed away from sources
of heat, sharp edges and should make as few bends as
possible.
• Check to verify the gas line connection will be accessible
when the appliance is installed.
• If the gas line connection is not easily accessible when
the appliance is installed, support the appliance above
counter level and attach the gas line to the appliance.
When the gas connection is made, slide the appliance
into the cut out. If the gas line connection is accessible
when the appliance is installed, slide the appliance into
the cut out and then attach the gas line. Be very careful
not to kink the gas line when lowering the appliance
into the cut out.
• Keep your fingers away from where the appliance will
be supported on counter. Your fingers could become
trapped and serious injury could occur.
• Check to make sure the appliance is level and is sup-
ported around the entire outside edge. If the appliance
is not level or is unstable, use non-combustible shims
under the outside lip to stabilize it.
• Make sure to perform the leak test procedure as descri-
bed in this manual.