lancer Twin Pour 30, Руководство по установке

Страница: 9 / 30

9
Dispenser Setup
1. Turn on water source.
2. Open the pressure relief valve located on the front of the
unit, by flipping up on the valve cap lever. Hold open until
water flows from the relief valve then close (flip down) the
relief valve.
The dispenser must be properly electrically grounded
to avoid serious injury or fatal electrical shock. The
power cord has a three-prong grounded plug. If a
three-hole grounded electrical outlet is not available,
use an approved method to ground the unit. Follow
all local electrical codes when making connections.
Each dispenser must have a separate electrical circuit.
Do not use extension cords. Do not connect multiple
electrical devices on the same outlet.
F
WARNING
3. Verify all Bag-In-Box contains syrup and check all
connections for leaks.
4. Place enough ice in the ice bin to fill approximately 1/2 of the
bin before plugging in the unit.
5. Connect unit power cord to grounded electrical outlet.
7. Test the ice dispense feature by ensuring that the ice auger
runs when ice lever is pressed.
8. If necessary, turn on the screen by pressing the power sup-
ply toggle buttons on the left side of the unit electrical box.
9. Once the screen has booted up, the service menu for drink
setup must be accessed.
10. Access the Service Menu by turning the keyswitch clock-
wise to the third position.
6. Turn on the power to the dispenser by pressing the on/off
toggle button on the right side of the unit electrical box and
turning the 3-way keyswitch to the vertical position.
A
A. Dispenser Power
On/Off
11. A keypad will appear, enter the designated pin number to
access the service menu.
12. For technician access to service menu, repeat step 10 and
enter the technician’s pin number
(4433).
13. For manager’s access to the service menu, repeat step 10
and enter the manager’s pin number
(6655)
.
14. For access to only the Sold Out Menu, repeat step 10 and
enter the Sold Out pin (963.) .
Le distributeur doit être mis à la terre de manière adéquate
pour éviter toute blessure grave et décharge électrique
fatale. Le cordon d’alimentation dispose d’une fiche à
trois broches mise à la terre. En l’absence d’une prise
électrique à trois conducteurs mise à la terre, employer
une méthode approuvée pour assurer la mise à la
terre de l’unité. Respecter les exigences du code de
l’électricité local au moment d’effectuer des branchements
électriques. Chaque distributeur doit disposer d’un circuit
électrique distinct. Ne pas utiliser de cordon prolongateur.
Ne pas brancher d’autres appareils électriques dans la
même prise de courant.
!
MISE EN GARDE
Sleep Position On Position Service Position