Table of Contents
3
Instrumentation for commissioning
72
O regulation
49 - 62
2
Adjusting load ratings individually
73
Automatic functions control
Entering an initial curve
73
during operation
49 - 50
Approaching control elements from one side
74
Adjusting the integrated O regulator (optional)
49
2
Entering settings
74
Checks during burner start-up
49
Entering top setting
74
O monitoring bands
49
2
Ignition delay when setting
74
O boundary curves
49
2
Pre-setting load automatically
74
Dynamic probe test
50
Entering the compound curves
Probe blockage
50
with the burner stationary
75
Correction output monitoring
50
Keeping the re-circulation damper
Regulation strategy
51 - 53
closed in pre-ventilation
75
With pre-setting for load changes
52
Setting the pilot burner (servicing mode)
75
Extended regulation strategy (air shortage)
53
Switching the burner on again
via the target value
75
Connection to O meter
54
2
Via analogue interface
54
Operator controls and display
55 - 56
System Operation
76 - 89
Mode switching
55
Mode display
76 - 78
Calling up O regulation text messages
56
2
Significance of modes on the FMS
76 - 77
O regulator modes
77
Commissioning
57 - 61
2
"ES" Mode progress (set-control)
78
Setting the correction range
57
Continue programming
78
Inputting the O target value curve
58
2
Calling up the correction range set
59
Calculation and setting of
4 Curve sets FMS (option)
79
control parameters-(manual)
59
Interconnection with 4 curve sets option
79
Lag time (parameters 898/900)
60
P-factor (parameter 899)
60
Checksums
Setting base value for "Deactivated
Running time meter
80
control” and "Air shortage”
61
Recalling the checksums
Calling up the base value for O regulation
2
and the safety times
80
deactivated/air shortage
61
Calling up running time meter
80
Automatic
61
Operation
62
Messages / Faults
81 - 89
The meaning of the additional modes
62
What happens in the event of FMS fault
81
Calling up O regulation text messages
62
2
Reading off a fault
81
Resetting a fault
81
Correction
63 - 66
Calling up fault history
81
Set correction input
63 - 65
O regulation perturbed
82
2
Setting the correction range
65
Air shortage perturbation
82
Recall set correction range
65
Resetting O errors
82
2
Altering the correction range
66
Calling up O regulation error history
82
2
Correction modes
66
Fault codes
83 - 89
Run to shut-off limits
67 - 70
FMS Fault Correction
Run to
shut-off limits
67
Aids
90 - 115
Checking the shut-off limits at the
General Faults (A)
90 - 94
three/point step output of the FMS
67
Three-point step control output (B)
95 - 96
Checking the shut-off limits at
continuous output of the FMS
68
Continuous output (C)
97
Tolerance limits direction air deficiency
69
Load signal (D)
98 - 99
Indication for an example protocol
69
Feedback (E)
100 - 103
Checking the O influence
69
2
Correction input (F)
104 - 105
Example protocol
70
Digital inputs (G)
106
Control unit faults (H)
107
Tips & Tricks
71 - 75
Leakage test
108
Programming 1st point
(ignition load point)
71
Parameters (P)
109 - 118
Programming with burner running
71 - 72
Programming with burner stationary
72
Reversing the programming
72
