42
43
www.howdens.com
Built-in Single Split Cavity Oven
LAM3676
Instructions and Installation
A
B
B
A
1
2
3
2
3
A
B
B
A
3. If your oven lamp is of type
A
shown in the figure below,
remove it by rotating as shown
and replace it. If it is of type
B
,
pull and remove it as shown in
the figure and replace it.
4. Install the glass cover.
If your oven is equipped with
a square lamp:
1. Disconnect the product
from mains.
2. Remove the wire racks
as described.
3. Remove the protective glass
cover with a screwdriver.
4. If your oven lamp is of type
A
shown in the figure below,
remove it by rotating as shown
and replace it. If it is of type
B
,
pull and remove it as shown in
the figure and replace it.
5. lnstall the glass cover and then
the wire racks.
Cleaning the inside
of the oven
To clean the side walls of the oven
(This feature is optional. It may not
exist on your product.)
1. Remove the middle section
plate from the oven.
2. Pull the wire rack and take the
pin
1
out of its housing.
3. Remove the wire rack
completely by pulling it out of
the oven. Ensure that pin
2
is
removed from its housing in the
back wall and that the tip
3
is removed from the screw on
side wall.
4. Clean the wire rack and the
side walls of the oven by using a
dish detergent, lukewarm water
and a soft cloth or sponge, and
dry it with a dry cloth.
5. Secure the wire rack pin to the
oven, so as their pins
2
can go
into the housings on the chassis
and the tip
3
goes into the
screw found on the side wall.
6. lnsert the wire rack pin
1
to its
housing found in the chassis.
