lamber PRL-C, Инструкция по эксплуатации

Страница: 26 / 30

26
ELECTRICAL CONNECTION
WARNING : Danger to life due to live
components!
During all electrical operations, disconnect the machine
from the network and verify the absence of
power.
The machine and its accessories must be connected in
accordance with local regulation, by a company
that is specialized in electrical installation
authorized by the competent authorities.
Before connecting the machine, check to
make sure the voltage outlet of the mains
is the same as the voltage specified on the
data plate of the machine.
For a correct selection of the cable rated
cross-section refer to the data reported on the
product data plate.
The cable cross-section shall not be inferior
to the one indicated in the “Technical data
and description” reported in the first page of
the present manual.
It is necessary to connect the equipment to
an effective ground installation, as specified
by the electrical safety regulations in force.
Chack that this basic requirement is complied
with and, in case of doubt, ask for a careful
check of the installation by a qualified
personal.
THE MACHINE SHALL BE CONNECTED
WITH AN EFFECTIVE GROUND CLAMP.
The manufacturer declines any
responsibility for any damages caused by
lack of an effective
ground installation.
WATER CONNECTIONS
Carefully comply with any national or regional
regulations in force.
Arrange a gate valve in an easily
accessible place, with a tap having a
3/4"gas thread spout at its end and connect
to the water inlet valve (fig.1)
This connection is required only for machine
with
pre-wash and any other dishwasher
equipped with steam condenser or
regenerator .
Water shall be supplied at a temperature
ranging from 10÷15°C and at a dynamic
pressure of 2÷4 bar (200÷400 kPa).
WATER DRAINING
Reachable from the machine front side after
opening the front panel (to do this turn the
two front screws out);
DRAIN
DES-SCARI CO-MATIC-2008
Arrange a discharge at floor level provided
with siphon and connect to the floor drain by
means of a hose provided with an adequate
inclination. Make sure the drain hose is not
choked in any way.
Make sure the drain hose is resistant to a
temperature of 70 °C.
Carefully comply with any national or regional
regulations in force.