lamber PRL-C, Инструкция по эксплуатации

Страница: 12 / 30

12
START-UP AND USE OF THE
PREWASH UNIT PRL-C
(For the independent unit)
The independent pre-wash unit PRL-C must be
connected directly to the rack conveyor system
of the main dishwasher.
The rack conveyor will work only when the
main dishwasher will be working.
First operations
Make sure that the main switch is switched on.
Drain lamp
Washing lamp
Drain /Wash Selector
START Pushbutton
Turn the selector switch “A”, placed on the side
panel of the unit, in position ON
The tank water feeding will start and it will take
about 3 minutes.
At the end of the tank water feeding the
machine is ready to start the prewash of the
dishes.
PRE-WASH OF THE DISHES
1) Check that the door is closed and that
the the frontal strainer drawer is
properly placed and closed in its
housing.
2) Place the dishes inside the baskets.
See the corresponding page for the proper
positioning of the of the dishes inside the
baskets.
3) To start up the unit we suggest to wait for
the beginning of wash cycle in the main
dishwasher. In this way also the rack conveyor
will be started.
4) Press START pushbutton “B” placed on the
side panel of the unit. The pre-wash jet in the
unit will begin (lamp “C” is lighted on)
5) Place the baskets to wash in the washing
tunnel.
The basket will automatically go on.
.
N.B. Introduce the baskets so that the dishes
and the trays are in parallel with the
dishwasher and facing the exit.
6) To stop the pre-wash, turn the selector
switch “A” in position OFF.
Please note!
The opening of the frontal strainer drawer of
the PRL-C unit causes the stop only of the pre-
wash pump. The rack conveyoring will continue
and so the washing of the dishes in the main
dishwasher won’t be stopped.
The opening of the door of the PRL-C unit
blocks the pre-wash unit’s pump and the rack
conveyor.
The EMERGENCY STOP pushbutton blocks
the rack conveyor and the wash only of the
main dishwasher.
TANK DRAIN
At the end of the daily operations carry out the
drain by turning the Selector switch “A” in
position “drain” (lamp “D” lighted on)
At the end of the drain turn the selector switch
in position OFF.