lamber PRL-C, Инструкция по эксплуатации

Страница: 13 / 30

13
STARTING UP AND USE OF THE PRE-
WASH UNIT
For a unit directly connected to the
machine!
The
independent pre-wash unit is connected
to the main pull-through dishwasher.
The tank water feeding of the pre-wash unit is
automatically carried out at the switching on of
the main dishwasher.
After about 2 minutes the water feeding stops
and the unit is ready to work.
WARNINGS DURING THE WASH
Open periodically the frontal strainer drawer,
remove the internal filters and remove the dirt
that has accumulate during the pre-wash.
To open the drawer is enouth to extract it. A
mechanical lock avoids the complete loss of
the drawer.
Attention !
The strainer drawers can be cleaned without
completely stopping the ongoing washing cycle
of the main dishwasher connected to the pre-
wash unit.
If the filters are too dirty, the pre-wash stops
automatically (the cycle lamp switches off)
To remove and wash the filters it’s not
necessary to completely extract the drawer.
Remove the internal filters and eliminate the
dirt that has accumulate during the pre-wash.
- Check that the inspection door is properly
closed
- Press START pushbutton to start again the
pre-wash cycle.
Attention !
Even if the machine is equipped with the above
mentioned security devices, risks of burns on
the arms are still possible.
As already written in the section “Warnings
during the wash”, never put your bare hands in
the hot and with detergent water of the tanks.
This can cause burns and skin irritations. If this
should happen, rinse the hands immediately
and abundantly with running water. Refer
anyway to the specificationsof the detergent
you use.
When the pre-wash is working, don’t open too
fast the door or the lower strainer drawer.
We suggest you to strictly follow the above
mentioned instructions to have the best
washing result.