Lucid Series RF Signal Generator
Portable User Manual
Rev. 1.1
18
External
– Use an AM source connected to the generator’s MODULATION IN connector
located on the rear panel. The Generator will accept modulating signals between DC and 100
kHz within ±1 V (2 V p-p) amplitude.
x
Push the
Mod On/Off
button on the device front panel to start the modulation and then
RF On/Off
button to output the signal.
3
3.2.2
FM – Frequency Modulation
Select on the device display the Modulation tab, and then click the FM button to show the frequency
modulation parameters. You can also push the FM button on the front panel to show the screen.
Figure 3.3 FM – Frequency Modulation
x
Frequency
– Set the modulation Frequency (Hz).
x
Deviation
– Set the frequency deviation of the carrier wave in (Hz).
x
Source
:
Internal
– Use the screen modulation parameters.
External
– Use an FM source connected to the generator’s MODULATION IN connector located
on the rear panel. The Generator will accept modulating signals between ±1 V (2 V p-p)
amplitude.
x
Push the
Mod On/Off
button on the device front panel to start the modulation and then
RF On/Off
button to output the signal.
3.2.3
PM – Phase Modulation
Select on the device display the Modulation tab, and then click the PM button to show the phase
modulation parameters. You can also push the PM button on the front panel to show the screen.
